Turn the knob counter clockwise until Main Menu is displayed and push in the knob to enter the main menu. Turn the until x1 is displayed and then push in the knob to select.ĥ. If something other than x1 is displayed, push in the knob to enter Mask Type and follow steps 4 and 5.Ĥ. If x1 is displayed you are good to go and you can skip step 4 to step 5. Turn the knob clockwise until Mask Type is displayed. Turn the knob counter clockwise until My Setup is displayed and the push in the knob in to enter My Setup.ģ. Push in the knob on the front of the machine to enter the Main Menu (the first one you see).Ģ. To put that setting into your DreamStation do the following:ġ. The DreamWear mask user manual says it's setting is x1. The DreamStation has a setting to adjust the level of air pressure relief for each Respironics mask. To post a message, you must create a free account using a valid email address. Should the chemist have configured a mask into the DreamStation? DreamStation Software Now Available EncorePro v.2.17.8.0 Apnea Board Hello Guest, Welcome to Apnea Board As a guest, you are limited to certain areas of the board and there are some features you can't use. The initial release, OSCAR v.1.0.0, will have minimal changes from SleepyHead v 1.1.0 and is primarily to establish the fork of SleepyHead. (04-22-2016, 08:38 AM)MrEGuy Wrote: Does the machine need to know what mask is fitted to allow for masks releasing the exhaled air at different rates? Could this explain why the DreamStation did not detect leaks? I also tried specifying a mask through the phone app but it did not list her mask. Mark Watkins, aka jedimark, is the author of SleepyHead which is the foundation of this Fork and as such we will be forever grateful.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |